Simple way to repair
SPEA 4040 Multimode Flying Probe Tester enables to repair the boards in a simple way, thanks to its ability of detecting fastly and with efficiency the faulty components, through the execution of parametric measurements on the faulty board.
The powerful software included makes the repair test program generation easier, also when the board documentation is not complete or not available at all. Leonardo Fly Repair Software can generate the test program through a reverse engineering process, by the off line acquisition of the board data.
Leonardo Fly Repair Software
Accurate and immediate diagnostics
Leonardo Fly Repair operating system has been designed to focus on the components that, on the basis of the signaled anomaly, can be the possible causes of the failure.
Leonardo Fly Repair tests only the components belonging to the failing chain, in order to highlight in a few seconds the non-functioning part.
Maximum coverage in fault detection
The high mechanical accuracy of Flying Probe tester probes enables to go beyond every problem of accessibility: testing can be performed also if there are no test pads, contacting directly the pins of the components to be tested, even if dimensions are miniaturized (also less than 0.05 mm).
The system can detect in accurate way also the anomalies due to I/O stages of the integrated circuits (analog or digital), thanks to the application of NZT technique, based on nodal impedance measurement.
The technique consists in the extremely accurate measurements of capacitive, resistive and inductive values, which are typical of each single net on the board considering a reference point, and enables to detect errors which are hardly detectable only through parametric measurements.